All Northgate Engineering Vacuum Tanks can be manufactured to fit your application and your truck. All of the vacuum units are manufactured by our skilled engineers and
specification can be requested by you. |
| |
|
|
| A typical specification could be: |
| |
|
|
Mild steel plate with two torrespherical ends. |
|
Tank fitted with one baffle and a rear manway. |
|
Tank to have a calibrated dip stick. |
|
Roll over turret full length with s/steel air operated hand rail. |
|
Front side mounted access ladder and a hose tray on either side of length of tank. |
|
Two top mounted manways also primary shut off with camIock fitting. |
|
Secondary shut off unit with pressure relief valves, vacuum gauge and drain ball valve. |
|
Inlet deflector plates with brass ball valves and cam locks/dustcovers. |
|
Outlet with brass ball valve with cam locks/dustcovers fitted to the lowest point of rear door. Also a wash out catchment tray fitted to the tank. |
|
EPA sample pot fitted with a ball valve and cam locks/dustcover. |
|
Sight glasses fitted on rear door. |
|
EIP holders fitted L/H, R/H, and at rear door of the tank. |
|
Rear work/rev lights brackets piping to houses wiring. |
|
Operating signage will be fitted to all valves and devices. |
|
All flexible piping will consist of steel reinforced rubber oil suction hose, and clamped with bolted clamps. |
|
Tank to be hydrostatic tested. |
|
Sandblasting, primed and painted in two pack enamel. |
| |
|
| Northgate Engineering is happy to advice on a specification to suit your application. Contact Us or ring (03) 9357 7307 to learn more. |
| |
|
|
| Vain, Blower and Liquid Pump are priced and supplied to your specification. |
| |
| |
Vacuum Tank - 11,000 LT
